#OMNI REMOVER WONT APPEAR UPDATE#
#OMNI REMOVER WONT APPEAR MANUAL#

If your seat belt is not long enough to wrap the shoulder belt around the back of the carrier use the traditional installation method. The shoulder belt should NOT be placed under the child restraint. When the shoulder belt wraps around the back of the infant carrier, it should be placed approximately 2.5” above the bottom of the carrier (on some LiteMax infant seats, this spacing is indicated by a polished surface area). Lock your vehicle seat belt and pull to tighten. To achieve this installation, route the lap belt through the belt guides on the infant carrier, then wrap the shoulder belt around the back of the infant carrier. The Evenflo LiteMax infant car seat allows the “European” belt routing method when installing the carrier without the base. Can I use the European belt routing method when installing the carrier of the Evenflo LiteMax infant car seat without the base?

#OMNI REMOVER WONT APPEAR MANUAL#

Please note that the newborn crotch buckle position may be used, following the directions above, even if the information is not provided in the instruction manual accompanying your Evenflo LiteMax infant car seat. NEVER use this routing for children weighing more than 3.6 kg (8 lbs). Make sure the anchor is completely through the middle or front slot and is lying flat against the seating surface. For the newborn position, place the anchor of the crotch buckle through the rear slot, then feed it up through the middle or front slot.

The Evenflo LiteMax infant car seat allows a “newborn” routing position for the crotch buckle. Can I shorten the crotch buckle on the Evenflo LiteMax infant car seat? The head pillow, harness covers and buckle pad are OPTIONAL for all Litemax seats, regardless of the date they were manufactured.Īs with any child using a child restraint, please ensure that all the other requirements set forth in the instruction manual for the child restraint are met. The following guidelines regarding the use of the infant insert must be applied:ĭate of manufacture or newer – infant insert is OPTIONAL for child fitĭate of manufacture or older – infant insert is REQUIRED for infants who weigh between 3 – 4 lbs and OPTIONAL for infants who weigh over 4 lbs.

#OMNI REMOVER WONT APPEAR UPDATE#

This update is a retroactive change to existing Evenflo LiteMax and SafeMax infant car seats. The Evenflo LiteMax and Evenflo SafeMax infant car seats have updated weight and height requirements, noted below, to allow their use with small occupants:Īpproval of your child’s healthcare provider Harnessing & Child Fit Can I use the Evenflo LiteMax infant car seat if my baby is less than 4 lbs?

Omni remover wont appear